[SOLVED] [Win7SP1 x64] SFC errors: 26 cbs/sfc corruptions, 18 SURT corruptions

[Roguediego]

Hey guys,

I would like to fix the errors that show up on my sfc scan. I have searched online on how to solve this problem and it seems like the best solution is to to do repair install, however, the setup fails with the error saying that the architecture is not correct. I have installed Windows (7 pro 64bit) over the old windows (7 pro 64 bit) and that did not work (not upgrade).

I have tried using SFCFix, this also fails.


Thank you!

 

[BrianDrab]

Hi and welcome to Sysnative. Sorry for the delay. Are you still in need of assistance?

 

[Roguediego]

That's fine, yes, if you could assist me that would be excellent.

Other info:
-Chkdsk reports clean windows
-RAM test works fine
-Surface test is a pass
-Manufacturer software to check for bad sectors in extended test reports pass

 

[BrianDrab]

Please start with the following.

Step#1 - System Update Readiness Tool (SUR)
1. Download and run the following file.
2. When it asks you if you wish to install, please answer yes. Note: It could take 15 minutes or more to run. Please don't cancel.
3. You will get an Installation Complete screen when it's done running.
4. Please attach the log from the following location. C:\Windows\Logs\CBS\CheckSUR.log
Please Note:: if the file is too big to upload to your next post please upload via a service such as Dropbox or One Drive or SendSpace and just provide the link.

 

[Roguediego]

Having a peek at the log it says it has fixed majority of the issues and that only 5 remain. Thank you so much!

 

[BrianDrab]

Please do the following.

Step#1 - SFCFix Script
Warning: this fix is specific to the user in this thread. No one else should follow these instructions as it may cause more harm than good. If you are after assistance, please start a thread of your own.

1. Download SFCFix.exe (by niemiro) and save this to your Desktop. If you still have this on your desktop from downloading previously, you don't need to re-download.
2. Download the file below, SFCFix.zip, and save this to your Desktop. Ensure that this file is named SFCFix.zip - do not rename it.
3. Save any open documents and close all open windows.
4. On your Desktop, you should see two files: SFCFix.exe and SFCFix.zip.
5. Drag the file SFCFix.zip onto the file SFCFix.exe and release it.
6. SFCFix will now process the script.
7. Upon completion, a file should be created on your Desktop: SFCFix.txt.
8. Copy (Ctrl+C) and Paste (Ctrl+V) the contents of this file into your next post for me to analyse please

 

[Roguediego]

Ran it and checking with sfc /scannow command all of the problems have been solved.

Thank you for your help!

 

[BrianDrab]

No problem. Take care.