Here comes some logs about the booting-failures in the following order:
1. Standard MS boot-log "ntbtlog"
2. "Bootdrivers_All" (excl not booted drivers)
3. "BootDrivers_ex_MS) (only 3rd party drivers incl dump-files)
4. "InstalledDriverList_All_incl_not_booted" (strangely enough HWPOLICY not booted is on the list but not WDBOOT?)
5. InstalledDriversList "DriverList_All" in HTML (incl not booted HWPOLICY and WDBOOT)
6. Driverview "reportbootdrivers" in HTML (missing both not booted files)
7. "WDBoot_not loading" (spec)
8. "hwpolicy_not_booting" (spec)
All of the above filedata comes from the same boot-session January 22 2019(checked!). Unfortunately these reports
are not presented in an easy-read format but the size of the better viewed html-format was not allowed due to forum-
policy. I can try to dispatch them separately later.
9. On another boot-session EhStoreClass did not boot (se spec file).
Perhaps enclosed files are redundant to FRST! Also take a look at "Load-count". Several files have very high counts incl ntoskrnl.exe. This
file is by the way in the top when it comes to latency-problems. In Task Manager I nowadays have 2 (two) ntoskrnl.exe-files. One as System (pid 4)
and the other as Registry. Process-Explorer can´t find any file-info about the Registry-file and it´s process and says it is "device not connected".
Looking inside the Registry-file process using other sysnative tools (Process-Monitor i.e) it looks normal!
One obvious failure is problems relating to MS Resource Monitor. After hibernation or normal systemclosing the RM will not start. I have to do
a regular reboot and sometimes more than one. This har been going on for a long time. The same goes for accessing internet. Have to do a re-
boot to get DHCP (and DNS). Computer otherways says it lacks IP-configuration. I think it is because of the missing HWPolicy-system file not
working! Not the adapter-settings per se.
Another example; When starting certain programs you can feel and see that you reach some short resource-limit. In particular I see it when the
programs (i.e when running on external servers) involved have to do a lot of saving during exiting processes. Program not responding for 5-10
seconds. And still I can not see or read any capacity-problems in i.e Task Manager regarding lack of Memory, Processor-power or say Disk-
delays or internet-capacity (I have 100Mbit). I have done MemoryTest in Win 10 with no error!
Regards