corrupt files

what do I do in this case???

  • step by step

    Votes: 0 0.0%
  • how to-

    Votes: 0 0.0%

  • Total voters
    0
What parameters did you use with chkdsk? If none, then I would stop it, and start it again using chkdsk /r and do so from an elevated command prompt (As administrator). And note on large drives, it can take a long time, hours, even overnight to complete. So as softwaremaniac advises, let it run until completion.

Note it is safe to stop chkdsk if it was started with no parameters because that is running in read-only mode. If you used /r or /f, for example, then it runs in read-write mode and it is best to let it complete or risk disk corruption.
 
Again, X can be manually assigned to just about any drive or partition. I used to use it all the time for my DVD drive to prevent drive letter shifting.
 
And just to confirm what's already been said, one of my external USB backup drives has been assigned the drive letter X on all machines on which I use them. The other one is V.
 
I meant RE - Recovery Environment. Are they booted from the RE and running chkdsk on X would be the recovery partition correct?

It's very likely they've booted into WinRE and then chose command prompt option. The command prompt title will say X:\ etc.
 

Has Sysnative Forums helped you? Please consider donating to help us support the site!

Back
Top